- Do curtain rods need studs?
- How long can curtain rods go without support?
- Where should curtain rod brackets be placed?
- How do you fix a tension rod?
- How do I keep my curtain rod from falling down?
- How do you lock a tension rod?
- How much weight can tension rods hold?
- Do curved shower rods take up more space?
- How much weight can a curtain rod hold?
- Will a shower rod hold clothes?
- Can you use a tension rod in a closet?
- Can a tension rod hold blackout curtains?
- Will tension rods damage walls?
- Why does my shower curtain rod keep falling?
- Do tension shower rods work on tile?
- Will command hooks hold curtain rod?
Do curtain rods need studs?
If there IS NOT a stud, you will use a drywall anchor and a screw.
The anchors are the white pieces in the below photo: Knowing which to use is very important — without a drywall anchor, a screw alone will not hold the weight of the curtain and rod.
If you do not have a stud finder, you can use a hammer and a nail..
How long can curtain rods go without support?
Over 96 inches, a third rod bracket is required as a center support; this is mandatory! Having said that, a 2 inch or 3-inch diameter pole can span a distance up to a full 12-feet without flexing or bowing using only two end brackets.
Where should curtain rod brackets be placed?
Each bracket should be placed at the height you previously determined and about four to six inches from the side of the window frame. (This will allow you to open the curtains completely.)
How do you fix a tension rod?
The caps on tension rods are often made of plastic, but even rubber ones are so incompressible that moist, smooth surfaces such as tile or fiberglass can’t hold them. You can fix that by gluing rubber shelf lining material to the ends with strong glue — two-part epoxy or contact cement.
How do I keep my curtain rod from falling down?
Here are some of the best practices to keep your curtain rods from sliding.Extend the Curtain Rod. … Strengthen the Rod. … Hang Your Brackets Wide. … Make Sure the Curtain Rod is the Right Size. … Tighten the Screws. … Use Rubber Bands. … Duct Tape. … Command Strips.
How do you lock a tension rod?
Remove the rod by compressing it. To store the rod, compress it all the way, then twist the narrower rod counterclockwise or clockwise to lock it.
How much weight can tension rods hold?
around 20 poundsHere’s a quick answer. A typical tension rod can hold around 20 pounds which is the usual weight of a curtain. Heavy-duty tension rods are capable of supporting more than 20 pounds.
Do curved shower rods take up more space?
Most curved shower curtain rods will provide up to 33% more room in the shower. The design of it keeps water inside the shower instead of leaking out onto the bathroom floor. It also keeps the wet, sticky shower curtain further away from your body so it doesn’t “attack” you like it does in closer quarters!
How much weight can a curtain rod hold?
For example, a well known manufacturer’s smooth Designer Metal rod will only hold . 9 lbs per foot and the fluted version only holds 1.5 lbs per foot. This means an 8′ wide window drapery cannot weigh more than 7.2 lbs or 12 lbs.
Will a shower rod hold clothes?
A shower curtain rod is not as strong as a regular closet rod. … Some aluminum curtain rods are strong enough to support some clothes, but their main use is to hang a single shower curtain. The rod should not be placed inside the closet without brackets, as the brackets will add strength and support weight.
Can you use a tension rod in a closet?
Set up a tension rod across the back of a closet or along a bathroom sidewall, set some handy S-hooks on it and you’ve suddenly expanded storage for jewelry, scarves and any other items that clutter up your closet.
Can a tension rod hold blackout curtains?
Most likely, yes. I’ve used a few shower curtain rods of similar design on painted drywall, and they do fine. Blackout curtains are not lead-lined or anything. … If you install the expandable rod carefully and don’t expect it to hold the heaviest curtains out there, it should work fine.
Will tension rods damage walls?
Tension rods can pull paint off the wall where the rubber end caps press. … A problem occurs when a tension rod is pressed up against a painted wall and a disc of paint comes off when it is taken down. Take steps to eliminate the damage a tension curtain rod can do to paint.
Why does my shower curtain rod keep falling?
From homeguides.sfgate.com: If the walls on either side of the shower are drywall, you may not be able to tighten the tension rod enough without cracking the walls. Closet pole holders will keep the rod from falling. … Paint them the wall color to hide them, or spruce them up with another color and make them a feature…
Do tension shower rods work on tile?
Tension rods are well-suited to fiberglass and tile showers, where you might not want to drill through the walls to mount the rod.
Will command hooks hold curtain rod?
Curtains are a great way to add charm to any home. … Many landlords don’t allow renters to drill holes into walls, which is necessary for installing curtain rod hooks. Fortunately, it is still possible to install curtain rods with Command hooks.